That CG MM is a very poor design.
http://www.rotaryeng.net/**motor.html<
http://www.rotaryeng.net/motor.html
We used a stock RX7 inter cooler on this FW package.
A P-port version would be icing on the cake with less
boost required for the same HP.
Paul Lamar
Paul,
With the overlap of intake and exhaust, is boosting a PP possible? Seems to
me that you would be pumping the intake out the exhaust port during
overlap. Seems this would work better for a PP Renesis.
Mark S Texas
Sure. With a big enough turbo it is good for 1200 HP or more in a 3 rotor.
The air in the overlap area is moving up from the exhaust port to the intake
port which blocks the movement of intake to exhaust bypass air to a certain extent.
Think of air as molasses. It has mass, inertia, stickiness, and viscosity :)
Yes a 3 rotor p-port side exhaust would be better but maybe not for a turbo
compound.
Gas turbines work for this reason as there is nothing physical to stop the hot,
high pressure combustion air from going backward through the compressor other
than the mass of compressed air coming down stream.
The rotary at high RPM is a kin to a continuous combustion turbine.
The intake and exhaust process never sleeps unlike a piston engine :)
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.