Subject: Turbo p-port 3 rotor
From: Rotary Engine
Date: 7/13/2011, 4:29 PM
To: AAA Put this in the To box


 That CG MM is a very poor design.
 http://www.rotaryeng.net/****motor.html<http://www.rotaryeng.net/**motor.html
<http://www.**rotaryeng.net/motor.html<http://www.rotaryeng.net/motor.html

 We used a stock RX7 inter cooler on this FW package.
 A P-port version would be icing on the cake with less
 boost required for the same HP.

 Paul Lamar

Paul,

With the overlap of intake and exhaust, is boosting a PP possible?  Seems
to
me that you would be pumping the intake out the exhaust port during
overlap.  Seems this would work better for a PP Renesis.

Mark S Texas

Sure. With a big enough turbo it is good for 1200 HP or more in a 3 rotor.
The air in the overlap area is moving up from the exhaust port to the
intake port which blocks the movement of intake to exhaust bypass air to a
certain extent.

Think of air as molasses. It has mass, inertia, stickiness, and viscosity
:)

Yes a 3 rotor p-port side exhaust would be better but maybe not for a turbo
compound.

Gas turbines work for this reason as there is nothing physical to stop the
hot, high pressure combustion air from going backward through the compressor
other than the mass of compressed air coming down stream.

The rotary at high RPM is a kin to a continuous combustion turbine.
The intake and exhaust process never sleeps unlike a piston engine :)

Paul Lamar

Paul,

That makes sense.  It just seems that a good street-ported turbo motor would
run smoother throughout the operating range.  I would also rationalize that
the turbo could overcome the added flow resistance of a side port and still
produce a whole bunch of hp.

Also, Lynn Hanover stated that p-port motors are very sensitive to exhaust
restriction.  Doesn't a turbo create lots of resistance to exhaust gas
flow?  It seems that this would be trying to force the exhaust gasses back
up into the intake.

Mark S. in Texas

Well Jim Mederer proved that one can get a lot of HP out of a turbo P-port.
How many turbo P-ports did Lynn build? :) Jim Mederer holds the current stock body land speed record with a 3 rotor 3 turbo's (yes one for each rotor) engine but I don't know if it was a  p-port or side port motor.
http://www.youtube.com/user/PaulLamar2#p/u/11/JUf_aWVVl7o

The side exhaust port was developed mainly for one thing and that was to reduce
misfire at idle RPM.
http://www.rotaryeng.net/side-exhaust-port.pdf
http://www.rotaryeng.net/New-rotary-eng.pdf

Yes the turbo can compensate for poor port aerodynamics but at the
expenses of higher fuel burn. Any aero drag in the intake systems is a negative
when it comes to fuel burn. It is a far more important factor than back pressure on the exhaust. Why? Because the pressure difference that causes the flow in the first place is lower in the intake system than it is in the exhaust system. That is why the max torque coincides with lowest BSFC in both PUTT-PUTT-BANG-BANG piston engines as well as rotaries. Max torque means the maximum amount of air is getting into the engine.

http://www.rotaryeng.net/intake.html

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.