Subject: CAS connector CAS polarity
From: Rotary Engine
Date: 7/14/2011, 10:24 PM
To: AAA Put this in the To box

If you still have the gear as part of the front stack rather than a spacer, just drop in a CAS and give it a try. I have no idea if polarity affects CAS pickups, but my home built crank trigger using Chrysler pick ups were affected by polarity. A positive going pulse had a nice flat front on it to trip the SCR but when reversed, the long slow build of the positive side had timing going nuts. Just switching the hookup wires got everything working fine.
Lynn E. Hanover


Well this could definitely be my problem. My engine was a salvaged Japanese domestic engine from a car which had been in an accident, evidently a front- ender. I pulled apart the engine and everything was fine except for the fact that one of the CAS connector plugs was damaged and there was a small hole in the front cover which I welded up. So, I'm not absolutely sure that in fact I wired them up correctly. Given that there are two sensors with two leads each, and there is a common lead going to both sensors, there are four possible configurations for the wiring. so I have a 25% chance that I have it right.

Ib a similar note, does anyone know where I might find the proper CAS connectors for the 93 13BREW?

Brian Trubee

Those are not hall effect sensor. They are called VR or variable reluctance
sensors. You will need a high speed scope to look at the wave form.
Down load the shop manual for the 93.
http://foxed.ca/foxed/index.php?page=rx7manual
The shop manual shows only 4 wires.


Paul Lamar

Ok, they are variable reluctance sensors. My question is: does it matter if the leads get reversed on either or both of the sensors? Say I get the correct two wires going to each of the sensors, but I reversed the polarity. Does that matter?

Thanks for the downloadable manual.

Brian Trubee


Brian

I searched a lot and came up with nothing for a reluctor connector. They are the same keying as some injectors, BUT the injector connectors will not fully engage to the point where the latch holds them in.

Robert

Tracy recommends cutting off part of the housing around
the connector and soldering wires on to the pins.
Page 23.

This will work of course but there is a better
way. It is called a Molex socket.
No need to saw off part of the connector on the CAS.

They are made in at least two sizes.
The .093 is a bit big but the .063 works fine.
Just solder a wire to the socket outside the CAS
and install them with a pair of needle nose plier.
Then fill the cavity with RTV or Epoxy if you wish.

It worked for me.

Paul Lamar


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.