Subject: Ok Here are the important flywheel measurements
From: Rotary Engine
Date: 7/14/2011, 11:33 PM
To: AAA Put this in the To box


I finally got to the hangar and measured out my S5 turbo flywheel and the
remains of my S5 flexplate.  The results are very encouraging, even as good
as the possibly could be to make the swap, but I only had ten min at the
hangar before I had to leave to pick up my daughter from daycare, so they
are one try and slightly sloppy... I make no guarantees.  The height
measurements of the flex plate were particularly suspect because, well, mine
is all warped and broken.

*Ring Gear Diameter* - Perfect fit.  As we suspected, same size, same tooth
spacing.

*Ring Gear Fore-Aft Placement* - As measured from the underside of the big
nut. (for all further reference, aft means aft in the CAR).  The flex plate
puts the aft side of the ring gear 1.290 inches from the front of the big
nut. The flywheel puts it 0.913.  So the flex plate puts the ring gear
(appx) 0.377 in. further aft.  This is actually fortuitous because it just
so happens that the ring gear thickness is .365 ...    So all we have to do
to fix the discrepancy is weld and extra ring gears onto to the flywheel
ring gear and there will be teeth that the starter can reach:(bottom of the
page.. the cost $80)
http://mazdatrix.com/flywheel.htm
It may also be possible to fix the discrepancy by changing the starter...
will look into that.

*Damper Plate Placement* - On the flywheel, the mounting surface is proud
(or aft) of the ring gear.  On the flex plate, the mounting surface is
recessed (or forward) from the ring gear. And it all pretty much works out.
That position on the flywheel will vary somewhat depending on which flywheel
you have and how much wear you have on the clutch slip surface. But on my (I
assume well-worn) flywheel the placement was 0.965 while the flex plate was
0.950.  Pretty damn close and given measurement error it might me meant to
be right on.  Or, any difference could be made up by trimming down the
spline on the damper plate or removing or adding spacers between the two.

So in my mind, a flywheel is the way to go.  Stout, easy to get, pick your
weight, only mods seem to be drilling the mounting holes and welding on a
second gear ring.

-- 
David Leonard

Turbo Rotary RV-6 N4VY
http://N4VY.RotaryRoster.net
http://RotaryRoster.net


You are not seriously considering a 30 pound cast iron flywheel are you? :)
If aluminum how must does it cost?
Here is what the new PowerSport used.

-------------------------------------------------

OK I see you gave the Mazdatrix link to the aluminum flywheel.

You don't have to weld on another ring gear which might damage
the aluminum. Just space the starter aft (car). In the aircraft move
it forward with a spacer. Since the ring gear is now forward (aircraft).

Will Tracy's damper plate still fit?


Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.