Ok, jean. Here they are.
The thickness of the plate is 2.1mm at the center.
The diameter of the central hole is 78mm
The inner circle of 6 bolt holes centers on a radius of 48.55mm and the hole dia
is 10.5mm
The inner set of 4 lightening holes is centered on a radius of 75.4mm and the
holes are 30mm in diameter.
the outer set of 2 lightening holes is centered on a radius of 108mm, elipses
with 15mm radii and 5mm between 2 rad centers.
outer 4 bolt holes are centered on a radius of 112.25mm and are 11.3mm in dia.
there are 4 slots, 8.3x30mm with a tab at 90 degrees to the plate. long axis is
45 degrees to the radius, centered on the 108mm radius.
Total radius to top of teeth is 160.6.
the outer geared ring is 18.2mm deep.
I did not measure the thickness of the ring gear, or complete depth of flex
plate along axis of rotation.
Hope this helps. Measurements may not reflect factory specification. Used a
digital caliper.
C. Smith
Just filling the large holes near the center would be major
improvement. That is probably where Dave's cracks started.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.