So just what / will my renesis cost installed ?   To date I appear to have done everything the dear way, but renesis motors and I seem to avoid each other here in OZ.   I bought my motor as a bare block for $1000, and have not seen one advertised since, in any shape or form.

To -P port, balance the rotors and put in new bearings on the E shaft and rotors, surface grind all wearing surfaces, around $2500.00

An -O ring kit from Tracy,  $300.00

Have the motor reassembled with totally new apex and all  other seals,  $900.00.


Then came all the -little bits that I did not get with the motor.

4 injectors at $60 each.

4 igniter coils,  $25.00 each.

Slide throttle and various alloy bends including those for the rad.  $500.00 New water and oil radiator  $1400.00

Bolts and similar  $100.00

Engine mount  $400.00

Oil filter, mount and lines  $200.00

Fuel lines and fittings  $200.00.

Set of alloy racing pulleys to slow the water pump and  alt.  $260.00

Alt and starter  $170.00

New flex plate  $160.00

Exhaust can (321 s/s)and full exhaust system  $1000.00

Exhaust gasket, nuts, 13B oil filler pipe and cap, dip stick,  $360.00

Rubber engine mounts, and isolated rod ends  $130.00 .

Then comes jeff doddridges mounting plate and his renesis water pump outlet. Tracy's redrive and monitor, plus controller.

A prop at $2500.00

Electrics to date  (wire , sensors)  $ $300.00

I must be getting close to the end ???   but there are cheaper options like buying a motor complete in the first place.  The states is the place to buy at the moment and get overhauled with our dollar being where it is.  As for time I have spent surprisingly little time on the motor to date, most has gone on getting my engine cowlings from scratch. Very nice vacuum bagged carbon fibre, but enormous time involved.  I leave you to add it all up as I get a head ache when I see what I have spent. That however will abate once it starts.

Neil.

I am sure you are at a disadvantage being in the outback.
If you lived in Melbourne or Sydney certain things would be a lot
cheaper. I was impressed by this place. They had a lot of low cost stuff.

JAP Performance

Phone     Fax    
+612 9601 6715     +612 9821 4525    

6 Kelso Crescent,
Moorebank,
New South Wales,
Sydney, Australia.    
www.japperformance.com

Here are some pictures.

Paul