This reduces the number of parts.
The flex plate can be .090" thick 4130 or anything up to 1/4 inch.
The damper plate has been reduced to one ring part instead of
a large thick Al plate four Al blocks and 16 rivets.
A large ring with twelve 1.375 inch holes easily
drilled on an NC machine. Only four of which are
used fro the rubber bushings. The rest are there to save
weight.
The Ford auto TX part is turned around 180 degrees
to nest inside the flex plate. Only 10 steel
10-32 screws are used to bolt it to the damper ring
instead of 20 rivets.
The rubber bushings and washers are the same.
No need to move the starter or change the damper
design as I suspect would be required with the RX8 flex plate.
What do you think Dave?
Paul Lamar
PaulIt"s a very nice set design Paul , i would like to make one suggestion
,turning the Ford auto tx par 180 degres and counterbore 6"dia by the same dept
of the ford part flange it will lower the weight and with the stator can be
counterbore of the face of damper ring and use the same an-3 bolts,a .500" thick
aluminum plate can do it which is close to Tracy bushing dept .562" also like
the idea of multi holes so we can add more rubber bushings for higher hp
Jean Prudhomme
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.