Subject: Damper and flex combined
From: Rotary Engine
Date: 7/17/2011, 12:43 PM
To: AAA Put this in the To box



 This reduces the number of parts.

 The flex plate can be .090" thick 4130 or anything up to 1/4 inch.

 The damper plate has been reduced to one ring part instead of
 a large thick Al plate four Al blocks and 16 rivets.

 A large ring with twelve 1.375 inch holes easily
 drilled on an NC machine. Only four of which are
 used fro the rubber bushings. The rest are there to save
 weight.

 The Ford auto TX part is turned around 180 degrees
 to nest inside the flex plate. Only 10 steel
 10-32 screws are used to bolt it to the damper ring
 instead of 20 rivets.

 The rubber bushings and washers are the same.

 No need to move the starter or change the damper
 design as I suspect would be required with the RX8 flex plate.

 What do you think Dave?

 Paul Lamar


Looks elegant to me.  Does the "Ford auto TX part" seat into the guide
bearing in the E shaft?


 Mark LaPierre


The input shaft with the sun gear does that.
The Ford part has an internal spline that runs on the input shaft.

The Ford part is the same as Tracy uses now and it can be salvaged and re
used by drilling out the rivets.


Paul Lamar


If you decide to make a run of these, count me in for one. Or whatever
solution is decided to be best.
C. Smith

This is going to hinge on what Dave says as he is our
chief part Zerstörer right at the moment.  Mark Steitel is
second in command with a p-port 3 rotor now flying.
I'll take over when I get a P-port in the RV4.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.