This reduces the number of parts.
The flex plate can be .090" thick 4130 or anything up to 1/4 inch.
The damper plate has been reduced to one ring part instead of
a large thick Al plate four Al blocks and 16 rivets.
A large ring with twelve 1.375 inch holes easily
drilled on an NC machine. Only four of which are
used fro the rubber bushings. The rest are there to save
weight.
The Ford auto TX part is turned around 180 degrees
to nest inside the flex plate. Only 10 steel
10-32 screws are used to bolt it to the damper ring
instead of 20 rivets.
The rubber bushings and washers are the same.
No need to move the starter or change the damper
design as I suspect would be required with the RX8 flex plate.
What do you think Dave?
Paul Lamar
Looks elegant to me. Does the "Ford auto TX part" seat into the guide
bearing in the E shaft?
Mark LaPierre
The input shaft with the sun gear does that.
The Ford part has an internal spline that runs on the input
shaft.
The Ford part is the same as Tracy uses now and it can be salvaged
and re used by drilling out the rivets.
Paul Lamar
You could add extra pairs of dampers for higher power if necessary.
Murry
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.