Paul,
I checked the spike-catching circuit wired to my starter yesterday
and noticed that the diode lead was attached to the small spade
terminal, not the large battery lead as I had indicated earlier. I
re-drew the schematic for your reference. Sorry for any confusion
this may have caused.
Mark S. in TX
I thought that was the place to put it Mark. The solenoid acts like an
ignition coil when you release the starter, and can create 300 volts. The
diode lets that dissipate safely before it ruins electronics.
Dale Davies
I think this is an important diode, and could easily be responsible for the
problems with the B computer if Mike did not already install one. Before I
installed one, I had to show up at my plane in the middle of the night on 3
different occasions to turn off my ELT and answer to the CAP. Luckily, one
day I actually noticed my ELT turn on when I shut off the master switch.
Turns out that spike was triggering my ELT despite the fact that the ELT was
not even connected to the electrical system or even the aircraft ground! No
problems since installing a diode.
--
David Leonard
Turbo Rotary RV-6 N4VY
http://N4VY.RotaryRoster.net
http://RotaryRoster.net
Dave,
What brand/model of ELT did/do you have? That's pretty interesting. Do you
have any idea how much current is consumed by the coil on your master relay? I
assume it's a continuos duty device?
Any place you have a simple switch controlling a large coil (solenoid, relay),
you should probably have a diode installed.. It will make the controlling
switch last longer, and can lower the incidence of noise problems on other devices.
Matt-
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.