Subject: Starter diode circuit - CORRECTED
From: Rotary Engine
Date: 7/18/2011, 10:24 AM
To: AAA Put this in the To box



 Paul,

 I checked the spike-catching circuit wired to my starter yesterday
 and noticed that the diode lead was attached to the small spade
 terminal, not the large battery lead as I had indicated earlier.  I
 re-drew the schematic for your reference.  Sorry for any confusion
 this may have caused.

 Mark S. in TX


I thought that was the place to put it Mark. The solenoid acts like an
ignition coil when you release the starter, and can create 300 volts. The
diode lets that dissipate safely before it ruins electronics.

Dale Davies

I think this is an important diode, and could easily be responsible for the
problems with the B computer if Mike did not already install one.  Before I
installed one, I had to show up at my plane in the middle of the night on 3
different occasions to turn off my ELT and answer to the CAP.  Luckily, one
day I actually noticed my ELT turn on when I shut off the master switch.
Turns out that spike was triggering my ELT despite the fact that the ELT was
not even connected to the electrical system or even the aircraft ground!  No
problems since installing a diode.
-- 
David Leonard

Turbo Rotary RV-6 N4VY
http://N4VY.RotaryRoster.net
http://RotaryRoster.net


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.