Subject: Starter diode circuit - CORRECTED
From: Rotary Engine
Date: 7/18/2011, 10:42 AM
To: AAA Put this in the To box



Paul,

I checked the spike-catching circuit wired to my starter yesterday
and noticed that the diode lead was attached to the small spade
terminal, not the large battery lead as I had indicated earlier.  I
re-drew the schematic for your reference.  Sorry for any confusion
this may have caused.

Mark S. in TX


I thought that was the place to put it Mark. The solenoid acts like an
ignition coil when you release the starter, and can create 300 volts. The
diode lets that dissipate safely before it ruins electronics.

Dale Davies


Kinda..  First, the switch will support an arc as it's opened, keeping the voltage transmitted into the power bus low..  Then, wired buses aren't efficient at transmitting signals with fast rise times, so the voltage that reaches other components will be further controlled.  Finally, though the generated voltage might be high (300 maybe), the stored energy is low (it's not a very high current nor a large coil), so properly designed electronics can easily stand it.

This brings me to another point..  There's a well thought out spec for design/test of electronics that will be used in airplanes. It's called DO-160.. Discussed on the Aeroelectric Connection.  It talks about noise immunity, brown out behavior, and the like. It specifies how large a spike a device should be able to handle, for instance. Designing and testing for the spec isn't difficult, and it makes bad surprises much less likely..  Check out what Bob Nuckolls has to say about it. (It's an industry standard).

Any 555 EFI system should be built with DO-160 in mind..


Matt-

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.