Subject: Harmonics and dampers
From: Rotary Engine
Date: 7/26/2011, 12:32 PM
To: AAA Put this in the To box


While poking about on the net, I came across this site. Paul, you are probably
aware of these people.  www.epi-eng.com   On the left side of the site is a
list of selections. In gear box products, there is a discussion of torsional
harmonics. For me it has some more information regarding what is going on,
possibly with respect to the flex plate failures and the forces involved. They
speak about NASCAR and F1 engines. I noticed that the F1 engines are not using
a CS damper as they are not needed. Only about 200 lb/ft torque. (Maybe they
could tend to come apart at 18,000RPM) Stroke is 1.5" so force on crank is
light compared to 3.5"  NASCAR engine. Probably part of why the Mazda engine
has not suffered e-shaft failures. The short stroke does not apply a torsional
pulsation into it like a boing boing engine does. It is there, but not as
strong. I wonder if the flex plate would fail quicker if bolted to a piston
engine and flown the same as the rotary engines. Maybe the crank or rods would
be looking for air first.

Dale Davies

Been around for years. I have never seen one in an airplane
at any of the air shows. The gear box is well over 100 pounds.

The torque variation power stroke overlap of a V8 is why less than a 2 rotor
never the less the V8 people tend to solve the problem with a heavy flywheel.

I don't think any stock V8 car engine has gone beyond 300 hours in an aircraft.

Paul Lamar

The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.