Subject: Harmonics and dampers
From: Rotary Engine
Date: 7/26/2011, 11:18 PM
To: AAA Put this in the To box

While poking about on the net, I came across this site. Paul, you
are probably aware of these people.  www.epi-eng.com   On the left
side of the site is a list of selections. In gear box products,
 there is a discussion of torsional harmonics. For me it has some
more information regarding what is going on, possibly with respect
to the flex plate failures and the forces involved. They speak about
NASCAR and F1 engines. I noticed that the F1 engines are not using a
CS damper as they are not needed. Only about 200 lb/ft torque.
(Maybe they could tend to come apart at 18,000RPM) Stroke is 1.5" so
force on crank is light compared to 3.5"  NASCAR engine. Probably
part of why the Mazda engine has not suffered e-shaft failures. The
short stroke does not apply a torsional pulsation into it like a
boing boing engine does. It is there, but not as strong. I wonder if
the flex plate would fail quicker if bolted to a piston engine and
flown the same as the rotary engines. Maybe the crank or rods would
be looking for air first.

Dale Davies

Been around for years. I have never seen one in an airplane
at any of the air shows. The gear box is well over 100 pounds.

The torque variation power stroke overlap of a V8 is why less than a
2 rotor never the less the V8 people tend to solve the problem with
a heavy flywheel.

I don't think any stock V8 car engine has gone beyond 300 hours in
an aircraft.

Paul Lamar

I got to reading on the epi site some more and am wondering if anyone has
measured the natural frequency of the flex plate with and without the damper
hub bolted up.

If the engine is running 6,000RPM the frequency of pulses is 200Hz. If the
flex plate assembly is at or near a multiple of this, there will be a failure.
When I worked at a compressor packager for the oil patch, some customers would
have the unit checked for natural frequency. Then if the piping frequency was
close to a multiple of the running RPM, the length or mass had to be changed
or supports added. If the pipe breaks you could have a big problem.

This and the alignment should be checked. I feel it is a good thing to check
before competing at Reno. Could save the sit down.

Dale Davies


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.