Subject: Silicone Bushings
From: Rotary Engine
Date: 7/26/2011, 2:16 AM
To: AAA Put this in the To box



  Hi Paul,
  How goes the cookie cutter for the Silicone Bushings? Tracy corrected me
 on
  the width.  It is properly 9/16 instead of 1/2.  I see that McMaster
 Carr's
  only go up to 1/2, so we should probably go with 2 sheets with adhesive
 and
  stick them together.

  If you haven't bought the Silicone yet, I will order it today and buy the
  cutters off you, then I will sell the left overs to anyone who wants them.

  Tracy shipped my drive today, so all I need is to machine my plate.  Is
 Jim
  offering to do it for me?  I can drive it up anytime this week
 (preferrably
  outside traffic hours), It also may just be worth while for me to get it
  done locally....  i hate that drive.

  --
  David Leonard

  Turbo Rotary RV-6 N4VY
  http://N4VY.RotaryRoster.net
  http://RotaryRoster.net


  Jim is working on the OD cutter tomorrow. We have the ID cutter and
  it works great.  I have enough for one damper plate so no need to order
  anymore just yet. We need to test this durometer and make adjustments
  if necessary.


  Paul Lamar

 Eh, what happens on "test failure"?

 --
 David Leonard

 Turbo Rotary RV-6 N4VY
 http://N4VY.RotaryRoster.net
 http://RotaryRoster.net

 You get a lot of back lash.

 How thick is the clutch friction surface  on that
 flywheel? Did you find some one to cut it down?

 Paul Lamar



I measured it at 0.08 but it seems thinner than that..   I have not found
someone to take it off yet.  Will look harder tomorrow.  Probably too much
of a pain to try and ship it.

-- 
David Leonard

Turbo Rotary RV-6 N4VY
http://N4VY.RotaryRoster.net
http://RotaryRoster.net

FED X is easier that UPS.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.