Subject: nickel-silicon carbide alloy
From: Rotary Engine
Date: 7/28/2011, 1:00 AM
To: AAA Put this in the To box


Paul

Just saw an article in Hot Rod mag Sept issue. A very limited
production V4 motorcycle engine designed by Katech Inc in Clinton
twnshp Mich. Here's what caught my attention: the block is cast in
356-T6, and "The block uses no liners; the aluminum cylinders are
plated with a thin film of nickel-silicon carbide alloy". Is this
approach possibly usable in the often discussed aluminum side housings?

regards Robert

Quite common. It is called Nicasil and was invented by Maule.
Widely used by BMW, Porsche  and others.

Works best on a cylinder. Not so good on a rotor housing.

Paul Lamar


George Grimes idea of using hypereutectic aluminum alloy and lift the aluminum
out like they did with the LS1 and Vega blocks in the late '60s and early
'70s. Requires a special process that leaves the silicone behind for the
piston and rings to ride on. Required tin coated pistons. The cast Fe rotors
would work well with this.

Dale Davies


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.