Hi Paul,
I just receive my finishing kit and found out the engine mount
Jerry Hey built for me a couple years ago has an inside diameter
of 1.1875 inch, it seems, and the leg I just received from VAN is 1.250.
I think VAN has changed the design recently.
Any way, what is the best way to solve this issue?
Thanks,
JP
Take some pictures of the mount and send me the jpgs to make
sure we are on the same page. We are talking about the same
thing.
It looks like Van fixed a problem.
I have a welder locally that can fix that if you wish
to send it to me. However shipping might cost a lot
more than a welder in your area. Make sure the welder you choose
can do tig. Where are you located?
Plan B would be to cut the leg diameter down by a few thou.
There are a few tricks to doing this like first welding on
an extension to the straight part. This is probably the cheapest
fix.
First check with Vans and see if they have some old ones lying around.
Plan C is buy a 1.25" reamer (expensive) if the socket wall is thick enough.
My guess is about $150.
There is not a lot of difference in the strength of the leg
it is mostly a stiffness issue. Perhaps some early pilots were
experiencing purposing. Discuss it with the guys at Vans
and ask them for the reason for the change.
Get back to me on that and scan that part of the plans and send me
a jpg of the dwg.
Paul Lamar
Paul,I talked to Van's today and they said they have not changed the size of the
nosegear leg. Jerry made mine also. Will have to check when I get home, I'm in
Oshkosh now.
Dale Harvey
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.