Subject: Adapting Tracy's damper to the RX8 flex plate.
From: Rotary Engine
Date: 7/30/2011, 8:48 AM
To: AAA Put this in the To box




Hey Paul,
I got my flywheel back from the machinist... it was pretty steep, costing
$350 including putting the starter in a lathe and taking down the flange,
  taking down the addaper plate (both to make the starter reach the ring
gear), take down the clutch surface, drill and spot face the holes in the
flywheel.
Then today I went and had it re-balanced, $35.
Other costs included new bolts for the fly wheel (it is thicker) Aircraft
Spruce, $10 shipped. And the flywheel itself, $225.
Then there will be the new silicone bushings, but that is not properly part
of the cost of the conversion, which totals $620.

Tracy mailed my gears back to me on Monday, so they should be here any
second.  The only other thing I need is the new bushings, and I should be
ready to get it all back together and flying..

--
David Leonard

Turbo Rotary RV-6 N4VY
http://N4VY.RotaryRoster.net
http://RotaryRoster.net

OK Jim and I will make them tomorrow. The tools are done.

Looks like my way is cheaper :) Especially if we get an order
for half a dozen. Then I can get the 4130 disk water jet cut.
No starters mods required.

I'll be building a prototype this winter and selling Mikes
current gear box.

Paul Lamar
                   

Paul i would like to bring you a suggestion,instead to weld your plate to the ring gear you can bolted to the RX-8 flexwheel and machined the excess of flexplate which is below the 4 bolts by leaving 3/4" ring below the bolts so you dont have to get it balanced and no welding so those 4 bolts will serve only when you start the engine


Jean Prudhomme

It adds mass near the rim which increases the tensile stress on the hub.
Better to just make a new disk out of thicker 4130 and weld on a ring
gear. Or Tracy can make a new damper that fits the RX8 flex plate bolt pattern.
If he did that I would suggest making the bushings larger in diameter
and making them out of silicone rubber for the higher heat resistance advantage.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.