Subject: Make your own 1000 pounds load cell. correction.
From: Rotary Engine
Date: 7/30/2011, 11:22 PM
To: AAA Put this in the To box

Opps mistake correction,

This is simple and straight forward.
You fill it with oil and screw in a gage.
The accuracy depends on how much you want to
spend on a pressure gage.
This one is $33 or so but you can get a real nice
one for about $100.

Everything else is trivial but you must have a
lathe.

The trick is to have the piston area come out to
one square inch. Then the 1000 psi gage reads out directly
in pounds. Shown here the body OD is roughly 2 inches
of aluminum round bar.

You level the airplane and put the tail wheel on a
bathroom scale. The tail wheel weight will probably be over
100 pounds as the eye bolt is well forward of the
CG when fastened to the motor plate. The load on the engine hoist
should be under 1000 pounds for most RV's.

 From this info you can work out the weight and balance.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.