Subject: New gear box and damper
From: Rotary Engine
Date: 7/30/2011, 8:01 AM
To: AAA Put this in the To box




 Hey Paul,
 I got my flywheel back from the machinist... it was pretty steep, costing
 $350 including putting the starter in a lathe and taking down the flange,
   taking down the addaper plate (both to make the starter reach the ring
 gear), take down the clutch surface, drill and spot face the holes in the
 flywheel.
 Then today I went and had it re-balanced, $35.
 Other costs included new bolts for the fly wheel (it is thicker) Aircraft
 Spruce, $10 shipped. And the flywheel itself, $225.
 Then there will be the new silicone bushings, but that is not properly part
 of the cost of the conversion, which totals $620.

 Tracy mailed my gears back to me on Monday, so they should be here any
 second.  The only other thing I need is the new bushings, and I should be
 ready to get it all back together and flying..

 --
 David Leonard

 Turbo Rotary RV-6 N4VY
 http://N4VY.RotaryRoster.net
 http://RotaryRoster.net

 OK Jim and I will make them tomorrow. The tools are done.

 Looks like my way is cheaper :) Especially if we get an order
 for half a dozen. Then I can get the 4130 disk water jet cut.
 No starters mods required.

 I'll be building a prototype this winter and selling Mikes
 current gear box.

 Paul Lamar

Paul On the RX-8 they have a spacer and i think it can be fit on your flywheel project also you can use the RX-8 bolts which are longerI send you some photos,the thickness of the flange is .787" thick and the reset is .170" deepIt might save you time and money


Jean Prudhomme

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.