Paul
Just saw an article in Hot Rod mag Sept issue. A very limited
production V4 motorcycle engine designed by Katech Inc in Clinton
twnshp Mich. Here's what caught my attention: the block is cast in
356-T6, and "The block uses no liners; the aluminum cylinders are
plated with a thin film of nickel-silicon carbide alloy". Is this
approach possibly usable in the often discussed aluminum side housings?
regards Robert
Quite common. It is called Nicasil and was invented by Maule.
Widely used by BMW, Porsche and others.
Works best on a cylinder. Not so good on a rotor housing.
Paul Lamar
George Grimes idea of using hypereutectic aluminum alloy and lift the aluminum
out like they did with the LS1 and Vega blocks in the late '60s and early
'70s. Requires a special process that leaves the silicone behind for the
piston and rings to ride on. Required tin coated pistons. The cast Fe rotors
would work well with this.
Dale Davies
-- Mahle.
Primarily world's best piston co. located in Stuttgart.
Steve Behr
Hello Paul,
speaking of coatings, what do you think of "cermet" and the
ceramic coatings offered by REC at
www.rotaryengine.com?
BTW I've adjusted my email settings, hope that works.
Graeme Riley
It does not do the job claimed when applied to rotors.
It is all BS. It comes off. When it comes off
it destroys the rotor housing. It looks like somebody sanded
or sand blasted the rotor housing wear surface.
The other problem is it is next to impossible
to get your money back or sue somebody in Canada or any other
foreign country for that matter. Some Canadian companies are OK.
Just another scam. Stay 100 miles away from this outfit.
There are ceramic wear coatings applied with a detonation gun that work on
aluminum. Mazda used them on the Le Manns 4 rotor.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.