Subject: In the market for a com radio,
From: Rotary Engine
Date: 8/11/2011, 4:55 PM
To: AAA Put this in the To box


I just discovered the Micro Air M760 cost $1100
   and the Flight Line FL760 cost $685 but both have the same wiring
diagram.

   Hmmm! Interesting. I am willing to bet they are made by the same company
   and are internally about the same.

   $685 is more like the right price as com radios probably
   all use the same integrated circuits as hand held's selling
   for hundred's less.

   I have not done a detailed comparison of the features
   yet but they are very similar with built in intercom.

   They both fit the same 2.25 inch hole in the panel.

   Paul Lamar

    They are not the same. In particular, Flight line model has separate
    music input.

    Henry Nee

Nice, so not only is it 2/3 the price, but it has additional
features!  That sounds like a bargan.  BTW, I previously sent you a
link where the micro-air was only $950.  No matter that is still
more than $680.

Got my gear box on yesterday, then had to remove and replace it today
because of a snubber sizing issue. Hope to be flying by the weekend.

--
David Leonard

Turbo Rotary RV-6 N4VY
http://N4VY.RotaryRoster.net
http://RotaryRoster.net

Snubber? What is a snubber?

I found my rubber hardness tester today so will
check the durometer on that silicone rubber.

Great. Did the new 4130 flywheel affect your weight and balance much?

I am going to order the radio from AC Spruce unless somebody
knows of a cheaper price. I will also order one of these break out boards
fromn www.winford.com to make it quicker and easier to install. I
can't imagine soldering all those tiny wires that are already
installed in the wiring harness. Right now it is wired for an Xcom I
think.

I would have to build a plywood work stand that would go up
and over the wing. Either that or rip out the entire harness
and start over.

These break out boards are great for wiring Tracy's computer as well.

----------------------------------------------------

These gold Amp connector pins can be reliably crimped to the end of
the wires much more quickly and provide mechanical support to the
wires with a bit of heat shrink tubing. They fit in the screw socket
strips that are on the break out boards. They are quite expensive,
gold being $1700 per ounce, but I think they are worth it.

(You did take my advice to buy gold a year a go...  did you not? :))
spruce

BTW the radio price at AC Spruce came down to $619 but they are out
of stock. They expected 20 to come in on Monday. Any day now. I
think they are made in Japan so they could be real bargains.

--------------------------------------------------------------------
This is a once in a life time bargain A/C radio.

It is a real jewel. Made in Japan and sold by Edmo Distributors. Inc.

Paul Lamar

Definitely time to build a sluice and prospect for gold. The flood waters a
month ago brought gold down. I went out with the gold pan for about 2 hours
last week and got about 20 - 25 pieces of flake. Panning is slow, especially
for flake.

Dale Davies

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.