Why is it important when dealing with flex plates?
http://en.wikipedia.org/wiki/Moment_of_inertia
"In classical mechanics, moment of inertia, also called mass moment of
inertia, rotational inertia, polar moment of inertia of mass, or the angular
mass, (SI units kg·m²) is a measure of an object's resistance to changes to
its rotation. It is the inertia of a rotating body with respect to its
rotation."
Also read gyroscopic forces.
http://www.gyroscopes.org/behaviour.asp
"When the gyroscope is spinning it can contain large amounts of stored
energy. Newton's first law of motion states that any body will continue in
its state of motion (still or traveling) until outside forces change it.
Because of the forces when the gyroscope is spinning, if it is moved the
gyroscope will try to 'compensate' for this movement. If we take the example
of a gyroscope's axle being clamped to the structure of the car (often the
cars engine behaves as a gyroscope because of its shape, mass and
rotations)."
"If the gyroscope/engine is spinning at a fairly high speed in a clockwise
direction, as seen from the back of the car and as shown in the diagram
above. When the car is turned to the right (clockwise from above) forces A
and B are applied to the structure of the car forcing the front end of the
car down and the back end up. If the car is turned to the left then the
front end of the car is forced up and the back end forced down. If the
gyroscope is spinning in the opposite direction then the reverse will
happen."
"However if the car was moved directly upwards, downwards, forwards,
back-wards or side-to-side the gyroscope would not apply any extra forces.
The gyroscope only applies extra forces when the car is moved at an angle
(turning left/right or when the front/back of the car is moved up/down).
This effect is known as gyroscopic precession."
These forces go through the flex plate out to the ring gear stressing
the flex plate back and fourth near it's hub thousands of times per minute.
In other words the ring gear attempts to continue to rotate in it's original
plain while the hub is being forced to change direction.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.