Why is it important when dealing with flex plates?
http://en.wikipedia.org/wiki/Moment_of_inertia
"In classical mechanics, moment of inertia, also called mass moment
of inertia, rotational inertia, polar moment of inertia of mass, or
the angular mass, (SI units kg·m²) is a measure of an object's
resistance to changes to its rotation. It is the inertia of a
rotating body with respect to its rotation."
Also read gyroscopic forces.
http://www.gyroscopes.org/behaviour.asp
"When the gyroscope is spinning it can contain large amounts of
stored energy. Newton's first law of motion states that any body
will continue in its state of motion (still or traveling) until
outside forces change it. Because of the forces when the gyroscope
is spinning, if it is moved the gyroscope will try to 'compensate'
for this movement. If we take the example of a gyroscope's axle
being clamped to the structure of the car (often the cars engine
behaves as a gyroscope because of its shape, mass and rotations)."
"If the gyroscope/engine is spinning at a fairly high speed in a clockwise
direction, as seen from the back of the car and as shown in the diagram
above. When the car is turned to the right (clockwise from above)
forces A and B are applied to the structure of the car forcing the
front end of the car down and the back end up. If the car is turned
to the left then the front end of the car is forced up and the back
end forced down. If the gyroscope is spinning in the opposite
direction then the reverse will happen."
"However if the car was moved directly upwards, downwards, forwards,
back-wards or side-to-side the gyroscope would not apply any extra forces.
The gyroscope only applies extra forces when the car is moved at an angle
(turning left/right or when the front/back of the car is moved
up/down). This effect is known as gyroscopic precession."
These forces go through the flex plate out to the ring gear stressing
the flex plate back and fourth near it's hub thousands of times per
minute. In other words the ring gear attempts to continue to rotate
in it's original plain while the hub is being forced to change direction.
Paul Lamar
Paul,
The ring gear does not want to rotate in it's original plain. It
actually wants to line up with the new vector generated by the car's
left/right turn. That's why the car is experience up or down forces
instead of being reluctant to turn That's why the professor at MIT
said it is "VERY NON-INTUITIVE".
If gyroscopic force is causing the flex plate failure, then scratch
marks on David Leonard's housing should be on the left/right hand side
of the housing because of the banking high-G turns. Could David
Leonard confirm the location of the scratch marks?
Henry Nee
It wants to rotate in it's original steady state plain. It must be forcedout
of that plain. Dave does some other mild acrobatics like
rolls and perhaps others as far as I know. A stall is a severe
test of a prop shaft due to the high polar moment of inertia as well as a
flex plate. So too is a spin. ?So too a rapid pitch up. It is all about
direction change speed. Stalls are 70 degrees per second.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.