Ok, So I have the new ADI system installed and working.... I think?
Some of you smart racing guys probably have experience with ADI.
Most of the instructions that come with tuning it are directed toward car
guys that have computers and knock sensors. All they do is turn the
system
on and the computer allows more advance because I is not sensing any
knock.
The only real advise I have so for for me is that I should be running just
less than the amount of ADI that it takes to bog down the engine. My
system
is a fixed flow so I don't have much choice but it seems to be about
right.
If I use straight water (which I did for initial testing), the engine bogs
after about 10-15 seconds of ruining the ADI system. But when I uses a
50/50 mix of water and denatured alcohol (too hard to find methanol around
here, but close enough) the engine does not bog.
So assuming my amount of ADI injected is about right, now I am supposed to
be able to lean to better power and advance the timing a little. But how
much? For the last testing flight I was using EGT for lack of a better
guide. When the ADI comes on, my EGT drops by about 30 deg C, and there
is
a hint of roughness to the engine. I can then lean a little and the
roughness clears up. For my test flight I leaned until my EFT came back
up
to where I normally limit it (890 deg C). But if I then add 5 more inches
of MAP, there is still a hint of roughness even at 890 deg and I get the
sense that it wants to be leaned a little more. But I am afraid to do
that... We are talking 45" MAP and 7300 RPM here (185 KTS indicated
(Vne) and climbing at 500 fpm).
So here are my questions:
Is EGT a useful tool here, and does leaning to get the EGT back to 890
make
any sense?
Since Methanol will do such a good job at preventing detonation, is it
safe
to lean further toward best power (peak EGT)? (note, that will be hard on
the turbo... I need to remember to bring the spare one to Reno)
How much advance do you think i can add? I was previously ruining 5 deg
ahead of Tracy's recommended initial set up. Can't give a number because
the EC2 retards the timing with higher MAP's. How much, I have not heard.
I can easily add one deg at a time using Ed's EFI monitor. But without a
knock sensor am really in the blind.
Thoughts?
--
David Leonard
Turbo Rotary RV-6 N4VY
http://N4VY.RotaryRoster.net
http://RotaryRoster.net
I have a knock sensor I can loan you if I could only find it. On the turbo
engine it screws into the center housing. It generates an audio sound you
can feed into
the music input of your intercom. I am sure that Mazdatrix has one.
You can get an amp from MSD. You need it now.
Paul Lamar
Hi, be careful of spark advance in a boosted engine. Normally spark
timing is pulled out with increasing charge density as flame speeds are
increased with density. If you are adding alcohol with the water you are
making the mixture richer. For max power you have to reduce the gasoline
delivery to balance the additional fuel as was done in WWII. The water is
what allows the higher boost pressure, the alcohol helps a bit with a small
octane boost to 100 LL and evaporative cooling. The main reason for the
alcohol in ADI is to keep it from freezing in the tank at high altitude.
You have to be careful about evaporating too much ADI in the manifold as it
displaces air requiring additional boost to get the higher density for
power, making more heat to get rid of... One of the things that killed the
Pond racer was too small engines and thinking that the alcohol fuel would
provide enough charge cooling by it self. Poorly placed sensor ports
apparently caused the engines to go lean in flight. Adding timing with ADI
is for NA engines, pulling out a bit of timing with boost is for
supercharging. You want to be fat and late to start tuning. Without
instrumentation you want to be a bit on the rich side with the Max ADI and
boost the engine can stand without blowing up. Dave Zeuschel was asked why
he didn't put NOS on the racing Merlins he built, " I can blow them up with
the supercharger, what do I need nitrous for?" Good Luck!
Murry I Rozansky
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.