There is the link Paul

http://www.youtube.com/v/WgdIE2t8QkM?

By the way i did have my housing made at the foundry in 356T6 and i should
get 2 sets by this week. They charged me $110.00 per set. It look a very good
price to me.

You shown in the past some mold for the side port inlet and
several peoples want it and you mention your foundry supply was to
expensive may be if you are interested i can put yourself on contact
with them they are located south of Tampa Fl,


Jean Prudhomme
              
That link is still not working Jean.

Sounds like a good price on castings.
We are not going to do any more side port intake castings.
P-ports are easier and cheaper and they make more power. They are also easier
to tune as the manifold pressure tap is always in the same
place.

Paul Lamar