There is the link Paul

  http://www.youtube.com/v/WgdIE2t8QkM?

  By the way i did have my housing made at the foundry in 356T6 and i should
  get 2 sets by this week. They charged me $110.00 per set. It look a very good
  price to me.

  You shown in the past some mold for the side port inlet and
  several peoples want it and you mention your foundry supply was to
  expensive may be if you are interested i can put yourself on contact
  with them they are located south of Tampa Fl,


  Jean Prudhomme
                
  That link is still not working Jean.

  Sounds like a good price on castings.
  We are not going to do any more side port intake castings.
  P-ports are easier and cheaper and they make more power. They are also easier
  to tune as the manifold pressure tap is always in the same
  place.

  Paul Lamar
                         

i TI try by the return of your e-mail and it work fine


Jean Prudhomme

Still does not work for me. What are the youtube key words?
What is the youtube subject?

Paul Lamar

                       
The flying men over the Canyons


Jean Prudhomme