Subject: Marine stern drive couplers.
From: Rotary Engine
Date: 9/3/2011, 4:40 AM
To: AAA Put this in the To box


Paul,

 Just a thought but has anyone looked at the marine outdrive couplers.
 They turn at engine speed and handle 260HP connected to a prop.  I saw one
 today at a buddys house.  It was a 17 tooth spline about 1"OD.  The hub was
 about 4-1/2" diameter.  The bolt pattern is the same as the rear of the
 engine crankshafts.  The engines used are Ford,GM (small block and big
 block) Volvo and anything else used with a Mercruiser, Alpha, or Bravo
 drive system.

 The space between the splined hub and carrier are filled
 with vulcanized rubber.

 I got the attached photos from E-bay listings as a
 sample and there are pages of them.  Some are $99 new some go up to $189.
 LOW polar moment of inertia.  If you want more flex for a small engine just
 drill holes in the rubber section.  The pilot bearing is in the crankshaft,
 just a clearance hole thru the coupler.  Splines are about 2" long.  I am
 reluctant to add options since we are discussing several already so if you
 preffer you don't have to post this..  I just thought it looked like a nice
 piece.


George,

I think I found the input shaft.

Are all of these 1 inch diameter standard spline?

What worries me is what happens if the rubber fails.
Is the prop totally disconnected?

Paul Lamar


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.