Subject: Marine stern drive couplers.
From: Rotary Engine
Date: 9/3/2011, 9:31 AM
To: AAA Put this in the To box


 Paul,

  Just a thought but has anyone looked at the marine outdrive couplers.
  They turn at engine speed and handle 260HP connected to a prop.  I saw one
  today at a buddys house.  It was a 17 tooth spline about 1"OD.  The hub
 was
  about 4-1/2" diameter.  The bolt pattern is the same as the rear of the
  engine crankshafts.  The engines used are Ford,GM (small block and big
  block) Volvo and anything else used with a Mercruiser, Alpha, or Bravo
  drive system.

  The space between the splined hub and carrier are filled
  with vulcanized rubber.

  I got the attached photos from E-bay listings as a
  sample and there are pages of them.  Some are $99 new some go up to $189.
  LOW polar moment of inertia.  If you want more flex for a small engine
 just
  drill holes in the rubber section.  The pilot bearing is in the
 crankshaft,
  just a clearance hole thru the coupler.  Splines are about 2" long.  I am
  reluctant to add options since we are discussing several already so if you
  preffer you don't have to post this..  I just thought it looked like a
 nice
  piece.


 George,

 I think I found the input shaft.

 Are all of these 1 inch diameter standard spline?

 What worries me is what happens if the rubber fails.
 Is the prop totally disconnected?

 Paul Lamar



Paul, The 1"  17 spline seems to be the same on all of them which makes
sense because the sterndrive is the same and they are adapting various
engines to it. The universal joint shaft shown may be for the bevel gear end
of the first shaft. There is a second (engine) end and also a verticle shaft
down to the lower unit.The only way to find out if there are lugs in the
vulcanized rubber would be to saw it in sections and have a look. I wouldn't
think a failure of the vulcanized connection is likely because it is used on
a high HP drive with the prop being run into sandbars and such aparently
without problems. The lower unit gears are the failure point. One I sw
yesterday had been run without lubrication since 1984 and the splines were
worn and it had surface degradation of the rubber but it was still
functioning. The prop was not the original and really banged up which is
sort of a test of the rest of the drive. It was apart due to a waterpump
failure and lower unit problems from being full of sea water.

        The real concern is can we  fit an adapter plate about 5/8" thick
and the coupler in the available space between the E-shaft and tracys
plate.  The dished area of the flexplate  gives some space, but the marine
coupler is at least 2" long (spline length) and it looks like Tracys damper
is thinner than that. A rossectional drawing of Tracys drive would be
usefull.To be a universal standardised cure it needs to fit existing
instalations without adversly affecting weight and balance or the prop tp
cowl clearance.

george grimes

Here is a collection of manual TX shafts. The splines in these vary
as well. The GM V8's were 1 1/16 26.

Tracy used a 1 inch 30 which is odd ball for an input shaft.

Here is what I have on Tracy set up dimensions using my latest design
of built in rubber coupler. The distance from the block to the adapter
plate 3.05 inches.


Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.