Subject: connections on LS-1 585 coils
From: Rotary Engine
Date: 9/4/2011, 12:35 AM
To: AAA Put this in the To box



Paul,
           Need help as to the correct way to wire up the 585 coils.  The four connections seem to
consist of A Earth,  B  Also an earth, C trigger wire, D power supply.  Which one is which and is
there any way I can test them with a multi meter to verify the correct ones?

Neil.


This is what I have Neal.

The only way I know to test them is set them up on the bench and
use a pulse generator with a narrow pulse output to trigger them.
-------------------------------------------------
Neal got any electronic types in that town you live in?

This  a real easy circuit to build that will put out a trigger
pulse for a LS or RX8 coil. It uses just any old square wave generator
for square wave out put and a very common $1 555 chip.

Set the generator to idle speed  of 1000 RPM or 16 pulses per second.

You can make one out of any drill motor lying around and a crank angle
sensor from just about any old wrecked EFI car. I am sure you have
a lathe to make an adapter to adapt the  trigger wheel/front pulley
to the drill motor chuck.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.