Subject: large water jacket O-rings
From: Rotary Engine
Date: 9/12/2011, 10:51 PM
To: AAA Put this in the To box




 I know, but I have to P port it first. The money I made from selling the
 parts off of the rx8 engine paid for this engine too. I will just need to
 get the big O-rings; and just why are those things so expensive?

 I'm going to line up the 6 rotor housings I now have on the table and
drill
 the P ports in them.

 I rarely walk into Pick Your Part without seeing an rx or two. I was just
 never aware how valuable the rotors and housings are on these things.
 Otherwise, I would have made a living out of it.

 Ed Carver


Creavey does'nt have an online products list for large rings that I can
see.
I need to order these soon, gotta call them I suppose? Atkins sells a whole
set on ebay for about $170. I really only need the big rings, but for both
the rx7 and 8 engines, so now we're talking $340.

Ed Carver

That is true.
They are all custom made. When you talk to Creavey tell them they are for
a Mazda rotary engine. People have been buying these sizes from them for 10
years.
You must do your homework on this.

Atkins does not make O-rings. Creavey does.
The stock inner square silicone O-rings are not reusable. The Creavey's
are.
The Creavey seal is totally encapsulated teflon while the stock seals have
teflon
on only one side.

I have had bad results from McMaster Carr. The 3/32 section
width is really .105 or more and not .096. Still too big. You need .093".

My experience is the Creavey's are cheaper than stock.

Paul Lamar
--


Hi Paul, do you have the dimensions for the rx8 oil o rings? I'm not ready
to take my rx8 engine apart yet so I cannot measure them.

Ed Carver

Sorry no RX8 rotor housings lying around right at
the moment.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.