Subject: large water jacket O-rings
From: Rotary Engine
Date: 9/13/2011, 12:47 AM
To: AAA Put this in the To box



 I know, but I have to P port it first. The money I made from selling the
 parts off of the rx8 engine paid for this engine too. I will just need to
 get the big O-rings; and just why are those things so expensive?

 I'm going to line up the 6 rotor housings I now have on the table and
 drill
 the P ports in them.

 I rarely walk into Pick Your Part without seeing an rx or two. I was just
 never aware how valuable the rotors and housings are on these things.
 Otherwise, I would have made a living out of it.

 Ed Carver


 Creavey does'nt have an online products list for large rings that I can
 see.
 I need to order these soon, gotta call them I suppose? Atkins sells a
whole
 set on ebay for about $170. I really only need the big rings, but for both
 the rx7 and 8 engines, so now we're talking $340.

 Ed Carver

 That is true.
 They are all custom made. When you talk to Creavey tell them they are for
 a Mazda rotary engine. People have been buying these sizes from them for
10
 years.
 You must do your homework on this.

 Atkins does not make O-rings. Creavey does.
 The stock inner square silicone O-rings are not reusable. The Creavey's
 are.
 The Creavey seal is totally encapsulated teflon while the stock seals have
 teflon
 on only one side.

 I have had bad results from McMaster Carr. The 3/32 section
 width is really .105 or more and not .096. Still too big. You need .093".

 My experience is the Creavey's are cheaper than stock.

 Paul Lamar
 --


Hi Paul, do you have the dimensions for the rx8 oil o rings? I'm not ready
to take my rx8 engine apart yet so I cannot measure them.

Ed Carver

Sorry no RX8 rotor housings lying around right at
the moment.

Paul Lamar



I asked Creavey if they had the dimensions for the rx8 rotor oil o rings. I
will hear from them tomorrow. Atkins claims in all of their ads that the
water jacket seals fit the rx engines from 87 on up through today. So I am
ordering two engine sets from Creavey for those. I'm just not sure about the
rotor oil o rings.

I measured the circumference of the water jacket seals today by using an old
seal that I cut to fit the groove. I'm sticking with your dimensions, as
they are for the ID, and not the center of the groove, which is what I
measured when I used the old seal. As and FYI, the circumference was about
3/8 longer.

Ed Carver

The rotor oil O-rings are not critical. If they melt the engine
smokes a bit on start up but then runs fine. I ran my Cosmo
for ten years with melted oil O-rings.

Paul Lamar


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.