Subject: things learned at Reno new studs
From: Rotary Engine
Date: 9/19/2011, 2:08 PM
To: AAA Put this in the To box


One other thing we are learning is apparently the engine
tension  bolts are lengthening under high boost (over 45 inches
of Hg) and  allowing some small amount of combustion gas leakage
into the  cooling system. Mazdatrix among other are dealing
with  it.


http://www.mazdatrix.com/studkit.htm

I am  still looking for 12.5 MM (1/2 inch) titanium studs
to save the  weight as 16 12.5 MM steel bolts are quite heavy.

The modulus of  elasticity  of titanium is about 16 million
while steel is 30  million.

The area of the stock 10 mm tension bolts is 78  mm
while the area of the 12.5 mm bolts/studs is 123.
That  makes the 12.5 mm steel bolts/studs  almost
twice as  stiff.

So the 12.5 mm titanium studs do not appear to be  stiffer
(due to the lower modulus of elasticity) than the  stock
steel tension bolts. Only weight is saved over 12.5  mm
steel.

http://en.wikipedia.org/wiki/Young%27s_modulus

Another factor is  pre load. If one can torque the tension
bolts higher that delays the  expansion to a some what
higher boost level. How much I have not  figured out
yet.

IMHO it is best to stick with 12.5  mm(1/2 inch) high strength steel.


Paul Lamar


Racing  Beat suggests torque to 32 pounds for boosted engines. I torque to
the lowest  end of the spec for a specific engine but I use Nickel
anti-seize compound on  the clean threads and under the bolt heads. Have a few spares
on hand as a  couple may be ruined this way. Never a problem.
Lynn E. Hanover

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.