Dave Leonard tells me his VDO pressure sensors are not living more than 20
hours so he is replacing them with a mechanical oil pressure gage.
Needless to say the oil pressure is critical to the life of the engine as
well as Tracy's gear box.
These are AN -3 brake lines but they will work as a reliable and robust oil
pressure gage connections for a MC Master
1.5 inch OD oil pressure gage. Yes one and a half inch outside diameter oil
pressure gage.
https://www.pegasusautoracing.com/productselection.asp?Product=3
You will need a jic steel NPT 1/8th pipe adapter to the gage and to the -4
an line.
We are not happy with the automotive oil pressure gage and it's nylon lines
that are in there now.
Paul Lamar
--
Paul,
Are you familiar with the trouble almost ALL 3rd gen 13Brew engines had with
their oil pressure senders/gauges? I've had 4 fail. Remote mounting is one
answer (with good grounds). Also aftermarket senders don't seem to be up to
the start up pressure and leak soon after new. I always have a back up oil
pressure gauge in my rew's.
Also, the threads on the block are something odd.
Marc Wiese
I think those threads are 1/8th NPT. That seems to work.
Larry Child looked at the sender and instantly recognized 1/8th NPT.
I assumed it was metric but no.... it is 1/8th NPT.
The high start up pressure was the reason I choose a 200 PSI gage.
Paul Lamar
------------------------
Paul,
The 3rd gen engines use an oil pressure thread on the block of 1/8 BSP, not
NPT----confirmed.
Marc Wiese
We have a second gen engine. BSP are straight threads therefor they require
a sealing washer or O ring. I have never seen that on a 2nd gen engine oil
pressure sender.
If it was a BSP we got all the way home with an 1/8th NPT screwed in. I guess
we lucked out. I think the slightly larger steel 1/8th NPT probably formed its own threads
in the cast iron. Of course max psi is only about 90 psi warm so the force on the fitting is
about 45 pounds. When you screw in a 1/8th NPT the thread is tapered and the torque
normally increases so I am sure one can be fooled. The first couple of turns go easy.
Are VDO pressure sensors available in BSP?
Any way here is some more info on the subject.
http://pipeandhose.com/node/2
"NPT/NPS and BSP threads are not compatible due to the differences in their thread forms, and not
just the fact that most diametrical sizes have a different pitch. NPT/NPS threads have a 60°
included angle and have flattened peaks and valleys (this is a Sellers thread form); BSP threads
have a 55° included angle and have rounded peaks and valleys (this is a Whitworth thread form)."
Dave will have to run a 1/8th NPT tap in there the next time he has the engine apart
or figure a way to deal with the chips when the engine is fully assembled. One way
to deal with the chips is to stuff a grease soaked string all the way down the gallery hole
and pull it out after taping.
Here is a dwg of the 1986 oil system.
BTW Pegasus has 1/8th BSP to 1/8th NPT adapters if one wants to go that route.
www.Pegasusautoracing.com
Of course all this has nothing to do with the pressure sensor living or dying.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.