Subject: Hose for oil pressure gage]
From: Rotary Engine
Date: 9/24/2011, 7:04 PM
To: AAA Put this in the To box


Dave Leonard tells me his VDO pressure sensors are
not living more than 20 hours so he is replacing
    them with a mechanical oil pressure gage.
    Needless to say the oil pressure is critical to the
    life of the engine as well as Tracy's gear box.
These are AN -3 brake lines but they will work as a reliable
    and robust oil pressure gage connections for  a MC Master
    1.5 inch OD oil pressure gage. Yes one and a half inch
    outside diameter oil pressure gage.
https://www.pegasusautoracing.com/productselection.asp?Product=3
You will need a jic steel NPT 1/8th pipe adapter to the
    gage and to the -4 an line.
We are not happy with the automotive oil pressure gage
    and it's nylon lines that are in there now.
Paul Lamar


Paul,
Found a 200 psi, liquid filled 1.5" gauge at "Surplus
 Center".........Price is right..........Would   need to order
 several items to make shipping worthwhile.............Link below
http://www.surpluscenter.com/item.asp?catname=electric&qty=1&item=21-1667
Kelly Troyer
"DYKE DELTA JD2" (Eventually)
    "13B ROTARY"_ Engine
     "RWS"_RD1C/EC2/EM2
     "MISTRAL"_Backplate/Oil Manifold
     "TURBONETICS"_TO4E50 Turbo

Price is good. Is it panel mount or thread mount? Panel mount would
have
studs and a bracket to hold it from the back. I am nervous
putting    mechanical    gauges in a car: Refer previous discussion
about Bourdon failures.    Also the    nylon tubing WILL fail and
dump oil all over. As regards our old buddy    Murphy,    that oil
will end up on a new carpet or your leg. If a mechanical    gauge is
preferred, I would use a stainless braid hose with teflon lining.
Best    in my    mind would be an electric gauge. A measure of the
electric gauge volts    and    amps and match up a transducer to
make it work. Some can be calibrated.
Dale Davies
Dale, you can create an extremely small diameter orifice in
the  fitting at block       that, if a line or gauge failure does
occur it will be noted on  the gauge with only a very     minimum
amount of oil lost per minute  of operation.

 rog

 Yup, generally noted as pulsation damper. Oil loss per minute may
be minimal, but at 15,000 feet you still have a mess to clean up if
nothing else. Hot oil on the leg sucks big time.

Dale Davies

Just hang  a catch can under it with a bit of safety wire :)

Paul Lamar


Paul,

You are going green! Just pour it back in to recycle it. :-)))

Dale Davies

Who me? No way :)

Paul Lamar


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.