Subject: Dodge 3.21 to 1 Gears
From: Rotary Engine
Date: 9/26/2011, 7:18 PM
To: AAA Put this in the To box


Paul,
Are you familar with these gears ?...........

Kelly Troyer
"DYKE DELTA JD2" (Eventually)
"13B ROTARY"_ Engine
"RWS"_RD1C/EC2/EM2
"MISTRAL"_Backplate/Oil Manifold
"TURBONETICS"_TO4E50 Turbo

No. Why?

Paul Lamar

Allison truck automatic trans  4000 TRV is rated for 600hp and 2,
000lbs tourque and has a first gear ratio of 3.51:1  assuming a max
prop rpm of 2,700 that gives you 9,477 engine rpm. Some of the
reverse ratios are up in the 5:1 range. Dave James

Allison or Dodge?
A bit high RPM for a aircraft gear box.
What do they weigh?

Here is what I have on Allison. Does not look the same. I'll
bet the parts are a lot more expensive. Have any weights or dimensions?

Paul Lamar

I I looked it up on the Allison web site, no weights were listed.
What is a reasonable weight to look for? Also if balanced and with
proper bearings and lots of lube, will the increased rpm exceed the
planetary system capability?

David James

Here are some weights of the Ford parts.

Not so far.

Paul Lamar


I think the 3.21 gears are from a Dodge 565 truck trans for behind the
Cummins. Probably a bit heavier than the Ford parts. Both are used with
diesels so they must be competitive. The Allison 3.5 gears will be robust to
say the least. They could be the answer for a race box on a turbo 4 rotor with
power recovery. I do not think the Ford or Dodge would stand up to the power
and RPM.

Dale Davies



-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.