snips...
On another note, I have located a new upper wing for my Glass Goose to
replace the one that was eaten up by the alcohol in ethanol gas. I'm going
to replace the wing and get 'er flying myself. I'm sure glad the Renesis ran
like a top. It'll give me motivation to get it going again after I finisha
SeaRey LSX.
Sandy McNabb
Renesis in a Glass Goose (on temporary hold)
Sandy, I understand that Briggs and Straton have an alcohol test kit
for auto gas. Â Rumor has it high test auto gas in some areas does
not have alcohol.
Paul Lamar
I was talking with Rich Martin the other day and he spoke with a gas tanker
truck driver who said
that as far as gas goes costco gas has the best additives. don't know if
they also add ethanol.
Might be worth a look.
Brian Trubee
-----------------------------
I just ordered a alcohol test kit from
http://www.fuel-testers.com/order.html  This was an subpage on a Briggs and
Straton site.
Here are a couple of sites to locate non-alcohol gas.
http://www.buyrealgas.com/ Â and Â
http://pure-gas.org/
You can also sign a petition against Ethanol on the Briggs and Straton site.
Hopefully, after the election the Republicans will can the ethanol fiasco.
It's costing us at the dinner table because of the increase corn prices to
feed livestock, not to mention the damage to our engines and hoses.
Sandy McNabb
Not a chance the Republicans will end these subsidies.. The corn
growers (and now the corn fermenters/distillers) now fund the right
people on both sides of the aisle to keep this going forever.
Cheers,
Matt-
Been reading this gasoline/alcohol thread, and it just occured to me, that
the way the test kit works, also seem to be the key to take alcohol away
from fuel.
It would be a fairly simple affair actually.
The test is based on the principle that alcohol and water mix,.... alcohol
and gas mix,.... but water and gas don't mix.
Plus, what will not mix...will stratify, into two different liquids, in two
layers with the most dense on the bottom, the alcohol/water mix in the
bottom, and gasoline on top.
If there is alcohol in the fuel, you will se an even mix, but if you ad
water, the alcohol will now leave the mix with gasoline and instead mix with
the water.
The test is basically that you take 10 units of gas, and one unit of water.
There is a mark on the test tube, where you fill it up exactly with water,
then you fill up the rest , to the next mark with the gasoline you want to
test, Â shake it, and let it settle, once it settle, the new stratified
liquid in the bottom, will be the water and alcohol mix, and depending on
how high up the water/alcohol mix goes in the test tube, compared with when
the level that was pure water, it will now determine how much alcohol there
is in the fuel.
It just occured to me...you have just now removed the alcohol from the
fuel....and it is now together with the water sitting in the bottom, ready
to be drained, and the rest on top , is fuel without alcohol.
Would you have 10 gallons of fuel, ad one gallon of water, and stirr it
briskly for a minute or so, and let it settle, (...I have seen in  the
test...it stratifies very quick,) you would get the same thing, Â drainout
the water/alcohol mix in the bottom and it should be alcohol free fuel.
Would'nt it ?
Roger
That will work. Â You will have to add an octane booster to
get back what the alcohol contributed.
Dan F
That technique will reduce the amount of alcohol in the gas, but one suchstep will not remove all
of the alcohol. The alcohol 'partitions' between the water phase and the gasoline phase, so to
remove a higher percentage, you need to do several steps -- add water, mix, drain water/alcohol
phase; -- add water again, mix drain water phase. The number of times youneed to do this is a
function of how low you want the alcohol content to be.
The other point already made is that the octane will be reduced when you remove the alcohol.
Bill Schertz
Bill would you check the hi test in your neck of the woods for alcohol content?
Paul Lamar
I can see a possible way to go here. Get fuel that is ...well almost alchol free, with water
treatment. Then either ad octanebooster or run two tanks.
At altitude ( not pressurized engine) the requirement for octane will decrease, with altitude.
Either have two tanks, one tank with high octane 100LL for take off and climb, then switch to lower
octane for cruise...or ad as mentioned an additive that will bost the octane rating for the whole
batch of fuel.
If an earlier statement holds true, that with water treatment, about 90% of the alcohol can be
removed, ....that means....if autogas, have 10% alcohol, and 90% of that is removed, there will be a
1% contents of alcohol left in the fuel..................will a 1% alcohol content, add up to a
whole hill of beans?
Roger
The Wankel engine runs fine on low octane fuel. Perhaps not when boosted to 45 inches of Hg.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.