Paul,

Made some progress on the heat shield.  I mocked it up using cardboard.
Will cut aluminum to see how metal works and then finally use SS.  It has
to be in 2 pieces as the engine moves and the duct does not.  the gap will
be covered with silicon sheet.  The plan is to cut a scoop in the upper cowl
and feed this space with outside air and vent it out the rear of the cowl.
The scoop will also feed the cooling air for the alternator.

Joe Berki
Limo EZ


Mr. Berki, are the P-port tubes in the photo aluminum? If so, how have you
sealed them? I'm getting ready to install alum tubes in a set I have, using
a type of alum solder to seal it all up.

Thanks!
Ed Carver


Why did you decide not to weld SS in Ed?


Paul Lamar