Got the gears for my new super simple gear box
with the four inch diameter aluminum prop shaft.
This does away with half a dozen parts and the need
to heat treat and grind a steel prop shaft.
This is the back Ford planet set with steel planet
carrier. Only about 7.5 pounds.
This will allow the p-port rotary engine to rev to about 9,000
for take off making close to 300 HP. Since Dave Leonard
went 230 MPH with his turbo rotary RV6 at Reno last week
my rotary RV4 ought to go about 240 MPH once I get the carbon
tail done.
It will be a while before I need it so I'll slowly gather
all the other needed parts together.
It will need a custom input shaft due to the large internal diameter
of the sun gear. I am not comfortable with a sleeve.
In effect the use of the stock planet carrier straddles the planet shafts.
I will have the current 1/2 inch planet shafts EDM-ed out to 3/8th while
they are still in the planet carrier. That way we will keep the stock
finish and hardness.
Six 3/8th inch diameter bolts on a 3.25" BC are over kill anyway.
There is room for six 1/4 inch dowel pins as well. The holes are
already in the planet carrier for those. I am not worried :)
BTW the planet carrier is not steel. Probably sintered powdered iron
alloy. We found that out today when we machined the teeth off.
John Lynch turned me on to high fatigue limit 7075 T73 for the prop shaft.
40K fatigue limit. The tensile is a bit down from regular 7075 T6.
He claims it is at least twice as good as 6061 T6.
He also says to chromic acid anodize. The one inch wall is way
over kill so I am thinking of machining it down where possible
to 1/2 inch to save a bit of weight.
Here is a good 7075 source. Sunshine Metals in Orange County
or Future Alloys in the San Fernando valley 818 701 1144
We used John's lathe today. He builds a lot of stuff for F16's.
He also did the 2nd landing gear design and build on the NXT.
Flying straight and level there is no radial load on the thin section
bearings with a planetary unlike a spur gear transmission.
This is so simple I should have figured it out years ago.
I had to get over my prejudice for using aluminum for a prop
shaft. Basically all it is; is a simple spacer between the planet
carrier and Warp-Drive/Sensenich type prop flange.
Sensenich is now making 50 HP blades for O-320 RV's.
This a a comparison with Tracy's box.
BTW rumor has it the stock Sensenich two blade hub cracks.
Paul Lamar
Paul,
I'm a bit thick in the head when it comes to things like gear
reductions.. Can you provide a bit more complete rendering of your
super-simple gearbox setup?
Will this work with an adjustable pitch prop - like the Ivo Magnum?
Regards,
Matt-
Not a good prop the IVO. Variable twist and not variable pitch.
But yes any electric adjustable with brushes and slip rings will work.
I am still working on an over all 3D. When I get it done I'll up
load it.
Years ago we designed and built an electrical adjustable two blade
prop for 250 HP. We just did not have the money to put it into
production. Perry Mick made the blades and others did some of
the design and Butch built the hardware. The slip rings were controlled
by a solenoid and would dis engage when not needed to save wear.
It was called the LAEV prop.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.