Subject: 3.17:1 gear box super simple PSRU
From: Rotary Engine
Date: 10/18/2011, 4:36 PM
To: AAA Put this in the To box



Paul

are you sure you want to use 7075??
I have a great source for 7050 with certs cheap cheap cheap it's all boeing
scrap.
maore than you will ever use. My machine is not being used at the moment.
I can machine the plates and squares
if you send me the drawings.

Tony

I'll get back to you when I get back from check rides Tony.
What dwg format can you use. We might try a built in planet
carrier on the 4 inch aluminum shaft.

Perhaps Ed needs something right at the moment?

Paul Lamar


This picture will give you a feel for the strength and robustness
of this type of four inch diameter aluminum prop shaft  PSRU.


Paul Lamar


That looks like it otta handle it. The shafts on the 2.85 are 4.17", which
leaves me with perhaps a .020 wall thickness; if I edm for 3/8 bolts. I
could likely find 9mm bolts and end up with about .030". I don't know what
the limit is for the lazer, or the minimum needed to provide a good surface
for the pinion bearings to ride on.

Ed Carver


That is a good plan Ed. Use the 9 mm bolts if you can find them. If
not use a 5/16th. That would be plenty strong enough.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.