Nice to see you back on your site Paul I am sending you some photos of the
design installation for the 2 stators installation  layout with the RX_8
bell housing.The Honda magnet fit exactly over the Ford spline housing and
can reuse the holes (6 of different circle diameter at 1/4 dia holes of
total of 12) .The Honda magnet wont need to be rebalanced but it a
different story for the Evinrude one.I made a sketch to find out how the
Evinrude magnet will fit and it seams a problem to clear the Tracy damper
rubbers washers , i have to design a spacer ring of .250" thick  to clear
those washers figure 1215 and figure 1210. I already wrapped the evinrude
magnet with carbon fiber and Milo offer to machined on his big late and i
was waiting to see how it will fit before sending it.The jeff plate mount
can be use between bell housing and engine by removing the inner part but it
will extend the prop flange 1/2".The prop housing split flange bolts can be
reused to extend the engine mount for better support near prop.Paul could
send me the outline engine cad layout it wi


Jean Prudhomme

                       
Evinrude and Honda stator installation with RX-8 Bell Housing
http://skydrive.live.com/redir.aspx?cid=83c64c1851927d22&page=browse&resid=83C64C1851927D22!246&type=5&Bpub=SDX.Photos&Bsrc=Photomail&authkey=jGK*tHnelDY%24




http://tinyurl.com/3auv8m7