My earlier question,
Question, can certified engines abandoned by failed manufacturers be built
new by another company if they follow the specifications of the original
manufacturer and still pass as Certified FAA under the original type
approved design ( weather home built kits or sold to general aviation
airframes ), has it ever been tested in law? Guessing more than one design
still has some commercial value even all these years later...
Kevin responded,
If I understand correctly, anyone can buy the type certificate, tooling etc
for certified aircraft and parts- however- they would have to go through
the certification process as a "facility" to get FAA-PMA certification.
This stands for FAA Parts Manufacturer Authority certification. Aviat
bought the type certificates for the Pitts planes and manufactures them-
but Aviat is already a certified manufacturer and has FAA-PMA certification.
So I would say the answer is yes- if you have the time and $$ to make it
happen.
As far as the comment about replacing the engines on the Apache with rotary
engines- here is what I know. I have a Bellanca Viking with an IO 520D that
recently gave up 2 cylinders. Because of 2 ADs, it is not feasible to
rebuild this engine. So I have an excellent certified plane, and to get it
flying again will cost around $35,000.00. Because of 2 cylinders.
I contacted the local DAR and asked about non-certified engines. He said
that I can apply for a certificate to allow me to install non-certified
engines on my plane "for testing purposes only". Its called a test program
and begins with a long Program Letter outlining the procedures, equipment
and testing requirements. I would be limited to class C or below airspace,
to not more than 40 miles from the home airport, and the cert would be time
limited. Also, no passengers not "critical" to the flight. Meaning if I
need someone to monitor gauges, equipment etc they can go. Other than that
its solo. At the end of the Program, the engine is either certified or
comes off and the certified engine is put back on. Before the engine can
be certified, it has to go through its own certification process- including
PMA manufacturing certification for whoever makes it and all of its parts.
The DAR said is was easier and much cheaper to buy another plane. As far
as the rotary goes- I am building a Wheeler Express. He said that I could
install the rotary on the Viking under the Program, and get the bugs out of
it if I wanted to go through the process. Then the engine is fully tested
when I put it on my plane. However (that word again) this would not
alleviate the 40 hour requirement for the new plane since it is
experimental and will have an experimental engine and prop. Theoretically,
if one has the data plate and certification information for a plane, an A&P
can rebuild the plane. If it passes inspection by an IA, its airworthy.
So, without the data plate and certification information, its not a
certified plane anymore. I would think that a person could go to an
aircraft salvage yard, grab up a fuselage, wings and tail and put
together an "experimental" plane. You would have a lot of trouble with the
51% rule and it might be akin to suicide, but...........
Kevin Alderman
N4839V
Why I asked if a FAA Certified Engine can be manufactured under the
original qualification is that I remember searching for information about
the Wankel Engine years ago, and seeing a development program by
Curtis-Wright, if I remember manufacturer correctly. If Curtis-Wright had
a FAA Certificate for aviation production of the wankel engine, would it
not be commercially viable to make new production certified engines under
that certificate? Of coarse given you can obtain the rights from whom ever
holds Curtis-Wright's assets.
GFCurtis Jr.
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.