Subject: Real World Solutions apex seals
From: Rotary Engine
Date: 11/12/2011, 6:53 PM
To: AAA Put this in the To box



Every time I see an engine torn down that used
these seals I get really angry. Not only do they
chatter they gouge grooves in the chrome plated $600 rotor
housings. Furthermore they do not have "crown". Crown
is  slight curvature of the top of the seal that fits the rotor
housing.

In addition to all that the apex seal springs supplied lose thier
height and temper.

If you have these seals and they are not installed or they
are installed and you have noty run the engine yet take them out
and throw them away.

Use only stock Mazda seals and Ianetti silicon nitride seals.

If they are already in your engine kiss..... your rotor housings goodbye.
The engine won't stop but it will be down on power and burn
more fuel than normal. That is a testimonial on the tolerance
the Mazda  rotary has for inferior parts.

Read this for more info.


http://www.rotaryeng.net/**seals.html<http://www.rotaryeng.net/seals.html

http://www.rotaryeng.net/**history.html<http://www.rotaryeng.net/history.html


Paul Lamar


I just took apart an 86-88 rx engine, the housings looked nearly exactly
like those in picture. I sort of assumed that mazda seals did not do that
to the housings. Except for the chatter ridges, they looked clean. I left
the whole lot in the yard, it was too wore out.

Ed Carver


It can be caused by lack of apex seal oil.
Many old engines have nylon apex seal oil injection
lines broken or cracked. These get brittle after ten years and
must be replaced. I have been bugging Mazda for years to change
these to steel brake line tubing. We of course do away with
them and mix the oil in the fuel.

The picture was of an engine that had the oil mixed with
the fuel.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.