Subject: Real World Solutions apex seals
From: Rotary Engine
Date: 11/15/2011, 11:37 PM
To: AAA Put this in the To box


Every time I see an engine torn down that used
these seals I get really angry. Not only do they
chatter they gouge grooves in the chrome plated $600 rotor
housings. Furthermore they do not have "crown". Crown
is  slight curvature of the top of the seal that fits the rotor
housing.

In addition to all that the apex seal springs supplied lose thier
height and temper.

If you have these seals and they are not installed or they
are installed and you have noty run the engine yet take them out
and throw them away.

Use only stock Mazda seals and Ianetti silicon nitride seals.

If they are already in your engine kiss..... your rotor housings goodbye.
The engine won't stop but it will be down on power and burn
more fuel than normal. That is a testimonial on the tolerance
the Mazda  rotary has for inferior parts.

Read this for more info.


http://www.rotaryeng.net/seals.html

http://www.rotaryeng.net/history.html


Paul Lamar


------------------------------------------------------------------------


This company has been re-profiling (grinding) the chrome surface back to
spec - they seem to have a good reputation and results last I heard.
http://goopyperformance.com/content/rotor-housing-refurbishing
They may be able to salvage some housings like this.

Tracy's apex seals appear to be hard on housings and less porous than
the Mazda seals.  I have seen housings that had no wear problems with them.
They seem to develop flat wear spots but they will also wear to correct
for chrome wear/flaking on the housing and have longer breakin times.
I have seen/heard of several cases where the apex springs lost temper
(lower Nickel content? affecting high temp resistance).

Tracy's seals seem to be more resistant to detonation and shattering
than the stock Mazda apex seals - they tend to warp instead, reducing
compression.
Ianetti ceramic seals have also been cracked by detonation with effort.

Cheers
Cary

Tracy and this Goopy company do not have a clue about how an apex seal works.
Sure the engine will run. It will also run WITHOUT apex seals if you
spin it fast enough to get it started. Do not put this junk in
an aircraft engine.

Read this again.

http://www.rotaryeng.net/seals.html

Correctly made  apex seals from Mazda and Ianette do not require any break in.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.