Subject: Mazdatrix one rotor LSA engine. RX8 ignition coils 2 ms dwell
From: Rotary Engine
Date: 11/18/2011, 10:08 PM
To: AAA Put this in the To box



One item you mentioned below needs some clarification.
The RX8 coil can not be used in a simple ignition as implied, because of the
2ms dwell time required. The trigger is at the rising edge of a 2ms square
wave, and coil firing is at the falling edge. This will give you a 90deg.
retarded ignition at 7500RPM.
I believe we talked about that already a few years back.

It would be nice, if someone came up with a simple electronic setup, without
a microprocessor, taking care of that.

Richard Sohn
N2071U
www.fairpoint.net/~res12/home.html

Real easy to do that Richard with a 555. It is called
a non-retriggerable one shot.

Paul Lamar

I missed your point at first. Yes I can see how that
could be a real problem at high RPM.

Use a small magnet on a rotating disk and use a hall effect sensor.
(MUCH MUCH cheaper than a Mazda CAS sensor.)
If you rotate the hall effect sensor relative to
the e-shaft  you can adjust the timing manually just
like a Ford Model T :)

BTW At high altitude 50 deg BTDC may be advantages for
lower fuel burn.

Perhaps I can come up with a centrifugal advance mechanism
similar to what was found in an old  distributer :)
I am working on it :) I notice Mazdatrix still uses
and old distributor from time to time.

Another way of doing it is use a cheap single chip computer
that has the sole job of advancing the ignition as a function
of RPM. It could read the RPM from Henry's tach.

I mocked the one shot circuit up on the bench.
Here are some scope picture with Henry's tach.

The top trace is the conditioned signal from the hall effect sensor.
The bottom Trace is the pulse going to the RX8 coil.

As you can see the lower trace stays at a 2 ms
dwell time over a wide range of RPM's.

The resister in the one shot is 4.7K and
the cap .2 uf. TLC555. Same chip as the 555 EFI.

If you want a PC board made download the free program
from expressPCB.com and I will design a PC board for
you that you can load into your copy of expressPCB.
You can then order the PC boards directly on the Internet.
You get three boards 2.5 inches by 3.8 for $51.
This company has very good service and it takes only
a couple of days.

That should hold at least 4 final 555 boards each for a
total of 12. Bottom line each board is $4.50 each. The parts
are about $10 or less. All and all a very cheap ignition
system.

Paul Lamar


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.