Subject: Mazdatrix one rotor LSA engine. RX8 ignition coils 2 ms dwell
From: Rotary Engine
Date: 11/20/2011, 11:41 PM
To: AAA Put this in the To box


 One item you mentioned below needs some clarification.
 The RX8 coil can not be used in a simple ignition as implied, because of
 the
 2ms dwell time required. The trigger is at the rising edge of a 2ms square
 wave, and coil firing is at the falling edge. This will give you a 90deg.
 retarded ignition at 7500RPM.
 I believe we talked about that already a few years back.

 It would be nice, if someone came up with a simple electronic setup,
 without
 a microprocessor, taking care of that.

 Richard Sohn
 N2071U
 www.fairpoint.net/~res12/home.**html<http://www.fairpoint.net/~res12/home.html

 Real easy to do that Richard with a 555. It is called
 a non-retriggerable one shot.

 Paul Lamar

 I missed your point at first. Yes I can see how that
 could be a real problem at high RPM.

 Paul Lamar


Paul and Richard,
If you use a Hall Effect sensor for your trigger you can use it to advance
the timing too. Kawasaki used this system with some of their old CDI
systems. They would space the sensor as far from the magnet as would
reliably trigger. Then as engine rpm rose the leading edge of the sine wave
would trigger the thyristor trip voltage sooner naturally. This would cause
the system to fire sooner and advance the timing. The max advance was about
12-15 degrees but it was enough to make a difference with not one moving
part. It worked perfectly, and there was no way for it to go wrong if the
sensor was still functional.
Bill Jepson

I was talking to Randy this after noon about the dwell phenomena and I realized
that I had forgotten that a capacitor discharge ignition does not do that.

If you are using a carb and you need a stand alone ignition just buy
an MSD capacitor discharge system. CD systems use the same old simple
coil differently. They do not use the rapid break down of the magnet
field in the coil to form the spark. They use the coil as a pulse transformer.
When the capacitor charge is dumped into the primary winding of the coil
it fires the plugs with no delay. Within microseconds. No need for a dwell time
to build up the current in the coil.

Of course this gives you no advance but it solves the retard problem
mentioned by Richard due to the required dwell time being a significant
amount of time relative to the time it takes the engine to make one
revolution at 7500 RPM.

You may want to add a mechanical advance for high altitude lean burn
as per the jpg.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.