Subject: One rotor ignition system. Relatively cheap round magnets. Zero weight increase.
From: Rotary Engine
Date: 11/30/2011, 7:12 AM
To: AAA Put this in the To box


One rotor ignition system.  Relatively cheap round magnets. Zero weight
increase.

The outboard motor type CD ignition is the simplest and cheapest.

It just occurred to me the magnets do not have to be curved if
they are part of the counter weight. That was the big hang up before.
We discussed this ignition in the past but we thought we needed
it built into Tracy's flex plate. That would have added a lot of weight.

http://www.kjmagnetics.com/products.asp?cat=168


You will need to reorient the 300 volts stater capacitor charging coil.
This has another advantage and it does not add weight to the engine.
You must have counter weights anyway.

There is no dwell time problem with CD ignitions.


If you want the simplest and probably the most reliable ignition system get
a two cycle one cylinder small outboard ignition system.


As close as you will come to a A/C magneto.

http://www.iboats.com/

http://www.iboats.com/Johnson-Stators/dm/view_id.271367

http://www.cdielectronics.com/
Down load the complete catalog.

Some of these stators are as low as $20 used.

The high voltage coils supply 300 volts for a simple CD system
and the other coils may supply enough 12 volt current for an EFI
system.  No belts.  If the main electrical system or alternator
fails the engine still runs.

This stuff is mass produced in the millions and extremely reliable.

All you need is a source of 300 volts, provided by the rotating magnet
and stationary coil,  a 1 ufd 300 volt cap and a switch of
some sort. An FET works fine and they are easy to use. Way back about 30
years ago we discovered that a 50 cent CMOS CD4050 or a CD4049 chip makes a
great FET driver if most of the six gates in the chip are connected in
parallel.

Since that times 1000's of FET gate drivers have been  designed
and built selling for as much as $6 each and so far I have not
found one that works better than a CD4050.  Many of them require
a regulated supply which lowers efficiency and cost more money
and parts.


I set up this simple CD circuit on the bench in half an hour with a 300
volt DC power supply and it works great.  The FET is a IRF740.

I am rapidly discovering it is all about the 300 volt power supply. You need
a robust power supply that does not crap out when it is shorted to ground
and that is where the charging coil in the outboard motor comes into play.

Nothing could be simpler than a large magnet passing a coil to rapidly
charge the 1 mfd cap.

Paul Lamar

Of course you are right again Paul, K.I.S.S. Keep it simple stupid, It
seems an obvious statement/mnuemonic but what you possibly don't appreciate is
that you are of the generation that started with houses that had no T.V. Travelled
through  the, Jet age, the nuclear age, the electronic age, the space age, the
cold war(start and finish) people of your experience,are a breed of diminishing
numbers. This only serves to increase your value!  I have learn't alot from this
site, and am most appreciative, to all the people that have contributed. Thank
you !!! It's likes creative masturbation.( If you catch my drift).

Graeme Riley

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.