Subject: Eccentric shaft end play
From: Rotary Engine
Date: 12/17/2011, 11:41 AM
To: AAA Put this in the To box

   I am performing an engine overhaul. The shaft turns smoothly and has end
   play without binding before performing the eccentric end play check. The end
   play is 0 and I have gone to a maximum spacer thickness of 8.12 mm spacer
   stamp s which gives a slight end play clearance until tightening the bolt.
   It still turns smoothly with a nice compression popping sound. The bearings
   are properly mounted on the spacer and 2 thrust plates are installed per
   procedures.

   Any ideas on this ?

   John P


   I assume you have the shop manual.

   One can download them from here free.

   http://foxed.ca/index.php?page=rx7manual
                            

   Paul Lamar

                          
 Paul

 I have the shop manual and other Info. I  overhauled  other rotary engines but may
 have ignored previous eccentric shaft end play.

 John P

 Final assembly must be done vertically as the needle bearing can
 fall out of place. That is about the only thing that can go wrong.
 Most manuals do not cover that well. In fact it shows it
 done horizontally. The 76 Cosmo manual is very clear on this.
 Step 1 is turning the engine on the engine stand so the front of
 the engine is up.

 What year is this engine?

 Maybe I am missing the point here.
 If so the attached pictures and above text are for the new guys.

 Perhaps you need to machine a longer spacer.
 I have a guy that can do that and he only charges $35 and hour.
 If so send me a spacer he can measure and  make a new one.

 Paul Lamar

                        
Paul

 I would like to take you up on your offer for a thicker spacer.
The only difference in the above listed spacers is that I would try a 8.14mm
thickness spacer.
The engine is a 1991 2nd generation. The eccentric end shaft is straight
30mm dia. The spacer inside diameter must be slightly larger for clearance.
The spacer od is 35mm-. The needle bearing race id is 35mm and rides over
the spacer.
Any of the above spacers could be measured and checked against clearance to
the 30mm eccentric shaft and 35mm id needle bearing races.
The additional required 8.14mm thickness is then required.
I will send a K stamp 8.06mm thickness which fits another engine and gives
the same required inner and outer clearances. The bearing race is included
to check spacer clearance. If the 30 mm dia eccentric shaft is available it
would be nice to check for clearance to the new spacer.
Please send forwarding address and cost.


Thank you
John P


I am guessing at the cost. Perhaps $50 if it is less than that I will put the
change in the box. If more than that I will eat it. The largest problem is coming
up with a piece of steel. If my local supplier has it in stock no problem if not
I have to mail order it and there may be a minimum. I really big bolt would work.
If you have a piece of steel we can use that.

Mail address is:
830 East Santa Maria St.
Suite 303 <<<<<<<<<<<<<<very important
Santa Paula CA
93060

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.