First response first. Mark, I am relating information I absorbed watching
reports on Smokey's hot air engine. The turbocharger/homogenizer performed two
functions. The first being to mix the air fuel into a homogenous mixture. The
speed of rotation and the blades chop up the incoming air and fuel into small
bits and in the turbulence mixes them. I you watch down a carburettor while
the engine is running you will see droplets coming out and breaking up into
small droplets. A throttle body injection is the same, but the droplet size
starts off much smaller. Use a timing light to stop action the droplets. As
you look farther down it becomes a fog. Some of the droplets do not vapourize
by the time they get into the cylinder. They become pollutants in the form of
carbon, hydro carbon.
The adabiatic engine theory of Smokey's is to mix and vapourize the fuel
before it gets to the cylinder. Now naturally aspirated, if you heat the
intake charge it is going to expand and a less dense mix will enter the
cylinder. This is the second purpose of the turbo, it is forced into the cylinder.
Now some fuel could condense on the cylinder walls/rotor surface or housings
but there is not much time for that.
On a piston engine, if an intake valve stuck open or leaked just a bit the
intake could be ignited. That is why a blow off like roots blown engines have
would be required.
The big reason for intercoolers/aftercoolers is to limit or reduce the intake
charge temp to get a more dense charge in the combustion chamber for more
power. Also involved is charge temp reduction to prevent detonation. This is
one THEORY of how stuff works. It does work for power. and you are correct in
stating to fix or work on one thing at a time. Maybe one person or team can
work on the PSRU, some one else the ignition, some one else the power
recovery/TC and some one else the economy.
The second response. The CVCC system was Honda's early attempt at stratified
charge. There was a third valve into a separate small combustion chamber that
had a resemblance to older diesel pre-combustion chambers. The idea was to
introduce a rich enough mix into it that could be ignited. The flame from that
would come out into the main chamber as it expanded still burning and ignite
the very lean fuel mix there. I am not sure how it worked out for economy, but
they do not use it today. The extra valve may have not worked well with the
extra throat in the carb to function with it.
The new plug/ignitions that are being worked on may be an answer to very lean
mixtures. Combined with an idea like Smokey's could make the rotary engine
very efficient. Possibly add in Paul's idea of a small rotary on the end of
the e-shaft for low power cruising with TC. One thing alone will not be the
answer. Mazda may have part of the answer with the 16X dimensions. Add a third
plug, variable geometry TC and possibly vapourized intake.
Dale Davies
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2011 All world wide rights reserved.