Subject: Cheap Simple One barrel carb for slide throttle.
From: "rotaryeng@earthlink.net" <rotaryeng@earthlink.net>
Date: 1/8/2012, 3:23 PM
To: AAAA Put this in the To box


   This is pretty self explanatory.
   To lean the carb you move the entire float
   bowl up and down.

   It is mostly made from Holley stock parts.

   BTW Mark S, if you are building a P-port from scratch
   you could keep one small side port for each rotor
   for the idle system.

   Paul Lamar

Paul,  It would seem that the slide  would be the throttle plate for the
carburetor and that a similar slide choke plate would eliminate the drag
of the choke plate at WOT.  As for the restriction of the venturi making
the intake diameter effectively smaller you might use a booster venturi
which is removable on several brands of carburetor and allows intake
 area  around  the outside of the booster.

                                                       George grimes


Thanks for the suggestions George. Can you make a 3D for me?

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2012 All world wide rights reserved.